[2.1.32] Layer volume changes in GUI and by controller handled differently

Hi,

I have some controllers on my master keyboard mapped to the mixer channel volumes.

When I adjust the volumes with the controllers, everything changes in the mixer as expected. But when I switch to another song and then back to the song where I did the adjustments, only the stereo out and song volume adjustments are retained, the layer volumes jump back to their values before the adjustments.

If I do the same adjustments with the mouse in the GUI, the adjusted values are properly retained when switching between songs.

Bit annoying, as I often do minor volume adjustments on the controllers while playing which I would like to save.

For reproducing:

  • Create a two song project, one layer per song (Halion as a default is fine)
  • This gives you three mixer channels per song - stereo, layer, song
  • Map some MIDI controller to control channel 1/2/3 volumes
  • Adjust the volumes in song 1 with the controllers
  • Switch to song 2 and back to song 1
  • Stereo and song channel will have the adjusted volumes, layer channel will not
  • Then do the same adjustments in song 1 with the mouse, switch to song 2 and back to song 1 - all adjustments will be restored properly

Just wondering - or is this behavior “by design” and on purpose?

… that’s a bug. But it needs a bit to get it fixed,
Michael.

1 Like