220v to 110v hardware

Hey all, I am currently after a compressor which does not have a 110-220v switch.
I was wondering if anyone else out there uses adapters in there set up and could tell me if it affects their performances.
Anyone else’s opinion is greatly appreciated.

I’ve replaced practically everything I had which ran on 110V and what remains I’ve replaced the power supplies in the devices.
I never noticed any serious degradation when running 110V 60Hz gear on a stepdown transformer from 220V 50Hz.
The volatage was in fact just a tad lower primarily to offset the dutyfactor (60-50Hz) but this was primarily of concern for motors (also had power tools).
Hope that helps some. :wink:

Nice one, time to get some imports :slight_smile: