Assigning Maschine knob to zoom level

Hello, I’m Sam, new here.

I’m struggling with that one, I hope someone can help me. I’ve managed to assign a knob on my Akai MPK249 to zoom in/zoom out, thus controlling my zoom level with one knob. I’d like to do the same with the knobs on my Maschine Mk2 controller. Unfortunately the increase and decrease messages sent by the Maschine controller are the same: a single Control Change number I can choose, with either 0 or 127 as a value, whereas the Akai knob was received by Cubase as 2 different control changes numbers, one for increase, and a different one for decrease. I’m not quite sure what I can do in the generic remote to get the same behaviour as the Akai from the Maschine…

In the end, solving this could help me a lot as I could apply it to other commands such as scrubbing for example.

Is there some MDI magician who could figure it out in here?

Thanks a lot guys.