Hello,
is there a “trick” to switch on the cycle at every song start?
Background:
Had a show and during soundcheck I disabled the cycle in order to get out of the loop to continue the song. So far so good. The problem starts at the gig, when the song just runs through the loop section where it normaly should stay a while. Yes it was my fault but can I do something to just turn on the cycle mode regardless of having it turned on or of before?
During the show I can toggle it via MIDI but if I send a MIDI at the start of the song, then it toggles so it can switch off the cycle if it was on already. If I set the Action to Button It just set the cycle to “on” and I cannot switch it off via MIDI during the Song…
Thank you for reading…
Cheers, Rainer
Sorry, that is not possible. The cycle setting is saved with each Song.