OP was corrected.
Also I’ve discovered three new issues while experimenting with this one.
Yes, three.
-
When the Definition tab is opened, the waveform size and other zoom and display settings get reset every time another Audio Event is selected in the Project Window. (Also happens when triggering the bug explained in this current Topic). As you might know, each Event in the project can have their own waveform size and zoom level independently, but when this issue gets triggered, it resets it for every single Event in the project. We even have a yellow pop-up “Zoom mode has been changed” or something like that… Completely counter-productive.
(Lower Zone Editor Definition tab resets the waveform Vertical Zoom level when selecting Events) -
When Auto-Scroll is enabled in the Editor, and the Cursor is placed outside of the Event (before or after, and eventual stretches caused by musical mode must be taken into consideration too), and when the Snap Point is NOT placed at the Event Start, toggling Musical Mode causes the Editor to perform a zoom out.
(Selecting an Event or toggling Musical Mode can make the Sample Editor perform a zoom out) -
Dragging and releasing the Snap Point on negative grid values then enabling Musical Mode can cause the Snap Point to jump to a random place on the Event, and eventually trigger the issue 2 from the issues wiki if it lands beyond the Event End.
I’ll post all of those three issues separately.