Can I connect a UR28M and a UR44 in Cubase 10.5 or 11 with Steinberg ASIO driver and use all inputs? I have Cubase 10.5, soon to be 11. I use UR28M but want a few more inputs and wanted to get a UR44 vs replacing UR28M with 824 or similar (I like the multi monitor and mix controls). Wouldn’t the UR28M and UR44 use same Steinberg ASIO driver so the could both be seen at same time? I read that you could only use one at a time (either or based on what you chose when opened up Cubase? I don’t want to try ASIO4ALL unless it’s really solid and wouldn’t lose latency ormmother features (wouldn’t even work). I really just need 6 inputs, so maybe I could just use the ur44 when I needed six and switch to mother ur28m when didn’t need, but not sure how that would work…if it did, could it be done within Cubase while open at least (without restarting)? I read sometuuing about clocking, but sincde both are in same ur family and both Steinberg can it be done to use both at same time, or at least switch between on the go while within Cubase? Any help or direction would be helpful. Thanks. (Also created topic in HW forum as I was uncertain which place was best)
Hi,
I’m sorry, it doesn’t work this way with Steinberg ASIO driver. The devices won’t be merged to one ASIO driver.