Centering text frame in Engraving Mode?

Hi everyone!

I’m creating an Instrumentation List in Engraving Mode. How do I center the frame “up and down” and “side to side”? Thank you.

Mike

Select the frame and open the bottom panel. You have a few different options there. If the frame is locked to all four sides, you’ll have value boxes listed as distances from the page margins. Make those equal and you’re all set.

If the frame is unlocked from one of the sides, you’ll have values for height or width instead, which will be less helpful for you in this case. Just re-lock the frame in the left panel (little blue lock icons).

Frames are set to Center vertical alignment by default, so that part should be already set.

1 Like

Thank you so much, Dan. What a great group of people!

1 Like