Changing Direct Monitoring Level

Is there any way to change the direct monitoring signal path level on a UR28M and Cubase? It is so low I cannot hear myself. I can work around it by linking everything else and lowering it but that is a pain

Maybe you should describe your current routing, components, and settings.

I have no complex set up, I just use the UR28 with direct monitoring ticked in Cubase’s device dialog. Otherwise everything is at defaults

Perhaps it’s something simple like the input level setting described on pg. 21 of the manual, otherwise have a look at the schematic in the rear of the Manual, it will show you which controls you have in the chain.