I’m an engineer who is using lots of STEREO BUS processing while mixin. So Im really struggling A LOT to reach my stereo out and turn to project and than again to stereo bus… Because when re opening the mixer window the output channel stays in the very right side of the mixer and I have to scrool again and again there… I think its really easy to put a separate part on the right end of the mixer and we can see our output channels immediately when we hit the F3 (may be it can be also in the lower zone mixer I dont know)
Check the visibility settings in the left zone of the mixer. You can pin channels to the left or right of the mixer.
You saved my life man !!! Thank you so much !!!
Not having the mains to the right would feel clunky, you’re welcome 