Hi N6 users. I am hoping that someone has experienced my issue and would be kind enough to share a fix or work around.
ISSUE: Control Room output buss in the bottom Control Room Section, when set to “Mix”, hears my three cue mix buss’s and headphone output buss when the CR cue and headphone sections are powered on and active.
Also , if I select the Cue 1 or Cue 2 or Cue 3 buttons in bottom CR section, I can hear my Mix blended in with the corresponding selected Cue mix.
The “Phone Out” section and buss in the CR behaves just as expected. No issues.
The three “Cue” Sections and buss’s behave as expected with no issues.
ACTIONS
(1) This is a clean install, so no imported preferences or templates.
(2) Created new VST Connection Input, output and Studio definitions several times.
(3) Made sure that the VST Connection Output buss’s were all disconnected as to not conflict with the VST Connection Studio output buss’s.
Below are my H/W and S/W configurations.
If anybody has experienced the above, any help would be most appreciated.
Cybermix
H/W CONFIGURATION:
RME UFX with 8 outputs located on back and headphone output on front.
1 CR Out L
2 CR Out R
3 Cue 1 L
4 Cue 1 R
5 Cue 2 L
6 Cue 2 R
7 Cue 3 L
8 Cue 3 R
9 Phone 1 L
10 Phone 1 R
S/W CONFIGURATION
VST Connection Output tab.
Stereo Out = Not Connected
Cue 1 Out = Not Connected
Cue 2 Out = Not Connected
Cue 3 Out = Not Connected
Phone 1 Out = Not Connected
VST Studio Tab
Cue 1 = Cue 1 Out = RME Out 3 & 4
Cue 2 = Cue 2 Out = RME Out 5 & 6
Cue 3 = Cue 3 Out = RME Out 7 & 8
Phone 1 = Phone 1 Out = RME 9 & 10
Monitor 1 = CR Out L & CR Out R = RME Out 1 & 2