Hi everybody,
Very puzzled,
I am exporting some stems, and something very weird happened.
The left and right channels are exported the wrong way around…
I deactivated the control room and all is back to normal.
Any ideas why this happens?
Cheers
Sounds like you’ve got your output monitor routing the wrong way round in the control room set up.
1 Like
Huh.. any chance you can gimme some direction how to do this? I’m not the best with the CR…thanks so much.
Not directly in control room……in the audio connections window where you assign outs.
Check those are the right way around…..but not sure it will be that as stems are never rendered through control room.
1 Like
Hey , thanks, will do.
yeah, that’s what really perplexed me….
NM….you already saw it. 
1 Like
Hi,
after you did a mixdown both with and without CR activated could you please reimport both tracks and check again if L/R are switched by direct comparison?
As @Grim said - CR should not have an effect on the mixdown so I’d be surprised if turning it on/off is the culprit here.
1 Like
Good God, I have no idea how this happened, but Left was set to Right and vise versa in the control room connections…
Thanks so much for your help!
Just me being a muppet
Thank so much for your help!!
2 Likes
lol…………..
1 Like
Isn’t that what I said in the very first reply?
1 Like
Yep , I marked it as solved. Good call!
1 Like
Haha, no worries!
Once, I accidently switched monitor cables at the back of my audiointerface. Although they are clearly marked as L/R I somehow managed to confuse L/R. I spent an hour checking every possible routing paths and VSTs until I finally realized that the culprit was right in front of me at the very end of the hardware chain. There was a lot of swearing going on that day…
1 Like
Yeap, coronary…we’ve all been there. 
1 Like