Cubase not reading automation

I’ve searched probably from here to the moon trying to figure this out. I create a simple automation by right clicking on LC on the stock EQ in Cubase and click on “Show Lc-freq automation track.” I then use my mouse to make points of where the low cut should be automated. It happens a lot to where it will just ignore the automation completely and will only perform the automation if i open the edit channel settings. But soon as i click on a different track it goes back to not reading the automation. It’s destroying work flow. If someone could help me out please this would be the end of all my troubles.

Ditto - My group channel is not reading my EQ off and on automation even though I see it has been written,