Hi, In the image I provided, I’d like to delete the Volta Bracket on the last measure (the one with the bracket and 4 inside of it). I was able to select it in Engrave mode but I cannot delete it. I can delete brackets in Write Mode, but in Write mode I can’t select just one of the two brackets, if that makes sense.
Thanks
Hi @faucetmusic424, to obtain this unusual hidden last repeat ending bracket, you can select it in Engrave mode and set a very hight Y offset value (so it will be pushed outside the page).
[OT: I wonder what should the singer sing at bar 21?]
thanks much!
I wonder what is happening the entire 4th “verse”; I don’t see any lyrics other than 1–3 ! 
— Jim
So, @faucetmusic424 it doesn’t need the repeat endings at all, just a 3x repeat and set the properties for the repeat barline…
You can’t delete anything in Engrave mode: only change its appearance. That’s the whole point of having Write mode and Engrave mode as separate things.
Though I’d agree: you only want to repeat at the end of verse 1 and 2: at the end of verse three you go on to the final chord.
I’m guessing the final chord is in lieu of the “first” ending, in which there should be endings 1-2 & 3. (Unless the intent is an instrumental 4th “verse.”)
thank you, but how did u get to that property panel? thanks
It’s the lower properties panel (ctrl-8 toggles it). Select the repeat barline and the properties for it will be found there.
gotcha thanks
