Dynamics not aligning properly in galley view

I’ve noticed this a few times in 5… what’s going on? There’s absolutely nothing else that could be effecting spacing.

in the properties panel, do you by any chance have a prefix or suffix turned on for the cresc? maybe even just a blank space will move the dynamic

maybe you moved it by accident in engrave mode
you could correct it in engrave mode

None of the above.

Here’s another section I just created from scratch, and again the dynamics are behaving weirdly

Screenshot 2023-06-23 at 4.06.17 PM

This looks to be the same issue as this thread from a couple weeks ago, which doesn’t seem to have been resolved, or even fully clarified. @dspreadbury, can you shed any light on this?

You can tell by the dotted lines that the selected dynamic is not aligned with the start of measure 405. Set the rhythmic grid resolution to an eighth note and press Ctrl/Cmd-Alt/Opt-Left Arrow.

It absolutely is. It was created by selecting the note.

Can you upload your project or a portion of one for us to look at?

If I start with your most recent image, set the rhythmic grid resolution to an eighth note and press Ctrl/Cmd-Alt/Opt-Left Arrow, I get this:
Image

I’ve not yet had time to investigate the problem first reported by Robby, but I will get to it in due course.

1 Like