Engrave Mode - Can't Drag System?

I have a file I’m working on with many different flows. One in particular is only three measures long, and when I go to adjust the layouts for the parts, I’m finding that these three bars are stretched the width of the page. This can be a little confusing to read for some. The only way I can see to adjust this is to grab the handle and use opt and the arrow key to move it over - one pixel at a time. For all twelve layouts, this would take me two hours. Is there any faster way to do this? Is there a way I can just drag the handle across the screen? I can’t seem to be able to do that.

Experiment with this:

Layout Options > Note Spacing > Only justify final system in flow when more then x % full.
Make sure you have selected the layouts in the RH column that you want this setting to apply to.

Also: opt + shift + arrow and opt + cmd + arrow will move the selected edit handle in greater increments.

1 Like