I’m not sure why that last rest refuses to stay in the staff…
I’ve tried manipulating the cue every which way. It would be nice to have a little more control over rests in cues.
I can’t share the project here, but I can email it if requested. Thanks.
+1.
I’ve also been very frustrated on occasions where, for instance, changing the stem direction of a note in a cue in Engrave mode also changed the stem direction of the actual note in the original part! I feel strongly that Engrave mode changes should not propagate backwards from a cue to the original.
Flipping a stem in the cue should not affect the original music, even if you have Set local properties set to Globally, but perhaps check that setting the next time you encounter this.