Help- getting clicks/drop outs at 192


Shouldn’t I be able to run my system at that level of latency dependably?

I could swear that I used to do it just fine…

Everything is updated (6.0.7) etc. Audio reads/writes to separate drive (7200 rpm), samples for Komplete are on a third…

Anything else I should check?


What buffer size you trying that sample rate at…

That is the buffer size.

latency setting?

That’s automatic based on how many samples you set the buffer at, right?

If I remember right it’s about 7.5 in and out for a total of 15 of so.

Can you not set more buffers?

192 KHz really stresses the system so a larger buffer size would be needed.

192 is the samperate, not the buffersize :confused:

Sample rate is 44.1.

Yes, buffer is set at 192.

Is that really that low?

Where do you guys run yours?


I’ll just go to 256 and see if that helps.

I’m starting to wonder if maybe the issue isn’t buffer/latency.

I’m just getting this sort of low level static sometimes- is there anything else I should try?


Hmm… 192 is a figure more commonly seen for samplerate? 44.1, 48, 88.2, 96…

Buffer sizes are usually along the lines of 64, 128, 256, 512, 1024…

I suppose 128+64=192!

Hence the confusion!

I swear it was 192! :smiley:

Anyway, just moving it up to 256 seems to have taken care of the issue.

Ok, like Split I didn’t expect that value for Buffersize :wink:.
It all depends on your processing power and plugins used. If you have plugins with oversampling, you may have to turn that off or bypass the plugin if you need lower latency.