Is there a way to set delay for multiple outputs individually inside Cubase?

Cubase
21

Screen Shot 2025-03-08 at 5.12.20 PM
Screen Shot 2025-03-08 at 5.12.20 PM1904×1045 199 KB

Screen Shot 2025-03-08 at 5.13.31 PM
Screen Shot 2025-03-08 at 5.13.31 PM1732×1029 118 KB

I just tested with hypothetical scenario with Cranborne 500adat - as my summing mixer - 3 stereo outs through ADAT - sum mix coming back into 7/8 inputs of ufx.

So far, this is a decent setup I got, I just applied Dangerous Music youtube method and with ‘monitor’ function to listen to the summing sound.

And also, I tried to bus it out to ITB ghost master bus I made, and it is pretty do-able, to… um, a/b

  • the sound out of summing mixer
  • the sound just within the box

I know it is not the best way but I will dig more later once the dsub cables arrive!

I think this dangerous music method would give me the least headache huh… :slight_smile:

(so far no stuttering, no latency issue - not that I could notice, so that is fortunate)

22

I am sorry in advance for all this~!

I have just re-done the test, with my dbx 160a
analog out (ufx channel 8 out) ---- dbx 160a input ---- 160a output ----- ufx 6 input.

Got the ping finally!

0.08ms (4)

So I guess, ping was working all along, but I had to ‘physically’ connect actual cable to return the ping through the hardware…

Oh man, silly me, my bad~! So now I will figure it out deeper for the best setup!

It is a bit more complicated that I thought, to get the ping sending and returning, I will think about ADAT connection again, and get it working!

But thanks! cubase and ufx ii were working all along :slight_smile: