[ISSUE] - Closing project error

Nuendo
1

The following crash/error log was created when I closed a project in Nuendo 6.5.
NUENDO_6.5_Yosemite_error.zip (24 KB)
Using Yosemite with a brand new iMac. MR816csx interface.

2

This same thing happens a lot. Not sure if there is a solution.

3

The important parts of this file to note are:

Crashed Thread:        0  Dispatch queue: com.apple.main-thread

Exception Type:        EXC_BAD_ACCESS (SIGSEGV)
Exception Codes:       KERN_INVALID_ADDRESS at 0x000000011d7b3e28

VM Regions Near 0x11d7b3e28:
    Image IO               000000011d645000-000000011d794000 [ 1340K] rw-/rwx SM=PRV  
--> 
    MALLOC_LARGE           000000011d8cb000-000000011d900000 [  212K] rw-/rwx SM=PRV  

Application Specific Information:
Performing @selector(select:) from sender SMTGCocoa1406046916_MenuItem 0x6080000c3cd0

and

Thread 61:

Thread 0 crashed with X86 Thread State (64-bit):
  rax: 0x000000011d7b3e08  rbx: 0x0000600000394290  rcx: 0x00000001054bae78  rdx: 0x0000000000000003
  rdi: 0x00007fff776582a8  rsi: 0x0000600000394290  rbp: 0x00007fff5fbfbe80  rsp: 0x00007fff5fbfbe70
   r8: 0x00000001054bae00   r9: 0x000000000000003f  r10: 0x000000000000000f  r11: 0x0000000000000000
  r12: 0x00007fff77658280  r13: 0x0000600000394290  r14: 0x00007fff776582a8  r15: 0x00006080008fcf10
  rip: 0x00007fff8849ef2b  rfl: 0x0000000000010206  cr2: 0x000000011d7b3e28
  
Logical CPU:     2
Error Code:      0x00000004
Trap Number:     14

This suggestion is not the root cause of the problem, but. Have you tried the following maintenance on your computer:
[1] Repair Permissions on the system drive
[2] Verify system disk (and repair if needed)
[3] Run a good RAM diagnostic program and maybe Reseat the RAM
HTH
\m/

4

PS - this might help - Do you have bad RAM? How to find it and how to fix it | Macworld

5

That Nuendo’s not ready for Yosemite just might have something to do with it as well!

Chewy

6

Thanks for the replies. I’ve repaired permissions already. I’ll try verifying the system disk. What’s a proper RAM diagnostics program to run? I’ll be a bit irritated if they shipped this computer with faulty RAM.

7

see my post three above this one. Given it is a new mac by the sounds of it, boot from your recovery partition is likely all you need to do to do a thorough test. I don’t expect it to be RAM but I have found that to be a more common problem than it should be and it is always good to rule that out.