Is this possible? Moving a selected automation point left and right with key commands works for me.
I found “Primary Parameter: Increase” but I can’t seem to figure out what it does. Anyone know, or know if this is possible?
Would be great thanks!
Is this possible? Moving a selected automation point left and right with key commands works for me.
I found “Primary Parameter: Increase” but I can’t seem to figure out what it does. Anyone know, or know if this is possible?
Would be great thanks!
As far as I know, just from the info line. But it is possible to do with key commands:
1.Edit info line (no default- you have to assign it)
2. tab once
2 ctrl- (or shift-)up or down to change value.
Awesome.
Thanks for the tips Steve!
Really helpful.