Media Bay preview only works with control room disabled?

Cubase
1

Media Bay preview only works with control room disabled?

2

No, it works as it should - in other words, you should hear a signal.
Can you post a sreenshot? You might have disabled something.

3

20241209_122137
20241209_1221371920Ă—1920 282 KB

20241209_122152
20241209_1221521920Ă—1920 220 KB

4

I Figured it out in control room next to stereo/mono there is a very small
area to activate control room,

20241209_122221
20241209_1222211920Ă—1920 353 KB

5

Hi,
please switch Studio/Outputs to Not Connected and activate Studio/Control Room to Out 1&2 or 3&4 depending on your setup.

6

Thank You for responding so fast! :wink: i didn’t expect a response for a couple days.

7

Someone is always around in this User forum. That’s why it doesn’t take long. :slight_smile:
Did you try?
If Control Room is activated you must route the Outputs exclusively through the assigned Outputs of the Control Room and disable the Outputs under the header Outputs. As a result, everything runs through the CR as it does in a studio.

8

Every Thing is Working well with my recent adjustments,
I am routing studio outputs to my MOTU 1,2-routing my control room outputs to
my MOTU 3,4- with Control room “CHANNEL SWITCH ON!” And control room set to mix.
this is working and i can preview my Media bay and hear it
and use Studio and control room outs together and separately,
and Thanks again for Fast response, I’ve been a member and user of the Forum since 2002
and Never Got such an fast response so thank you again.

2 Likes