As per attached. When I view this document in single pages vertically [via View–>Pages], I do see bars 32-35. But when I go into single pages horizontally, I am missing bars 32-35. Maybe I could move bars 32-35 to page 2? Not sure how to do this though.
Thanks
She’s My Uptown Girl.dorico (925.1 KB)
It looks like there has been quite a lot of manual staff spacing done in the Staff Spacing sub-mode of Engrave mode. A quick fix is to go into Engrave mode and choose Staff Spacing > Reset Layout in the Engrave menu. Manual spacing (and all sorts of other manual adjustments/tweaking) is usually for fine adjustments if satisfactory results can’t be achieved by using the Vertical Spacing settings in Layout Options.
Thanks. I did try that but then lines 27-29 disappear in horizontal view but not vertical view.
When I did what I described (I did it in Dorico 5, which is the version used to create the project), all bars became visible - in horizontal view and in vertical view.
Page 1 consisted of 7 systems (bars 1-4, 5-9, 10-13, 14-17, 18-21, 22-25 and 26-31), and page 2 consisted of 7 systems (bars 32-35, 36-39, 40-43, 44-47, 48-51, 52-55 and 56-60). Because there was already a frame Break at bar 32, that system was at the top of the second page.
She’s My Uptown Girl - layout reset.dorico (888.4 KB)
I downloaded your layout reset and it was as you described. I might’ve done some additional adjustments in the layout settings after my posting that caused lines to not be shown. I’ll go with your layout reset file. Thanks for your help
HI @Yavor_Kresic, you gave the solution checkmark to you own reply, which is not useful for other users: the Solution post will appear highlighted at the beginning of the thread.
You may want to consider giving one of the posts by @StevenJones01 the Solution checkmark, instead.
Fixed them all up except for one. System didn’t like the amount of corrections. In another hour