lycalp
July 27, 2022, 11:34am
1
Hello everyone
Is it possible to have more than 1 Noteperformer in a project, so that I would have every instrument in the mixer alligned as a SINGLE controller…?
At the moment I always see only the first instrument in the mixer… But i would like to control the volume of Chorus II, Sopran, Alto, Tenore, Bass individually…
Janus
July 27, 2022, 11:39am
2
lycalp:
But i would like to control the volume of Chorus II, Sopran, Alto, Tenore, Bass individually…
You can use Noteperformer’s own mixer to control relative volumes
1 Like
Here’s an expression map by @David_Tee which achieves what you want:
Hi all,
I’m attaching a Playback Template that creates separate outputs / mixer channels for all NotePerformer instruments that show up in Dorico’s Project Templates.
To do this without overloading the system, all the endpoints have the Instrument and Master reverb settings set to 0.
Reverb and other effects can then be applied in the Dorico Mixer.
A couple of important caveats:
Setting up NotePerformer this way uses a lot more CPU (over 200% instead of under 100%) but about the same RAM. …
4 Likes
lycalp
July 27, 2022, 5:08pm
5
Hello klafkid
… That’s exactly what I searched for!!! @David_Tee : Amazing work! Thank you very much for all your help and best wishes!
1 Like
lycalp
July 27, 2022, 5:09pm
6
… Thank you pianoleo for your support and help!!