Only one channel out

Cubase
1

I am trying to resurrect an old (circa 2012) project to repair on of the files. I am using LE4 (since that is what it was done in) on a new machine which is running Win10.

This is the I/O device setup shows output on Line out 3 & 4

When I open up Cubase this is what the setup looks like The output is trying to go to 1 & 4 (Via VST connections under devices). This message can only have 1 embedded scan, so I can’t show this.

OK obvious mismatch there so I change it to 3 & 4

First possible issue, Is there something I must do to keep this setup? Some kind of save operation?

So I load a tune

Low and behold, it’s back to 1 & 4

So I change it again. Both output show up as active on the mixer and the transport bar.

Only now I get nothing. What am I missing?

Been through the getting started documentation. Found nothing there

Thanks in advance,

2

Hi,

The Output setting is stored in the project, not globally. So if you make the setting before loading a project, it becomes overwritten by the project setting.

Therefore, you have to load the project, change the setting and save the project.

Btw, with LE license (based on the Soft-eLicenser), you are allowed to update to the latest version 15 for free, here.

3

Thank you.

I guess I should have figured that out, But since I am in recovery mode, I was hesitant to save the project.

I think it is strange that it would have been saved in that weird setup in the 1st place,

This recovery is becoming a hassle. Missing files, VST effects no longer working……