Hello All
Two low priority requests:
Firstly, I wonder if it would be possible to extend the MIDI parameters that identify a MIDI command mapping to a key commands in the preferences section of the system.
In the command below I use a Program Change rather than a CC which is helpful but then I might get stuck if I need to use MIDI PC commands for another purpose.
At the moment if I assign a MIDI command to a CC controller it does not allow me to specify either the MIDI channel or the CC value which forces me to use a new CC for each key command assignment. I think it would be better to be able to use a single CC for a range of commands each with a different CC value to distinguish it.
Secondly, in the expression maps, when setting an absolute value for a “Channel Switch” command I would like to be able to set the MIDI port number in addition to the midi number.
Kind regards
James