Programming Generic Remote

Yesterday I used a lot of time to program a Generic Remote to use with Lemur on iPad Pro.
This morning I opens Cubase and half of the commands that I programmed yesterday are gone.
Furthermore Cubase doesn’t remember the port setting and I have to set the sending/receiving port every time I start.

I think this is the way I often spend time with Cubase: redoing the work that I did yesterday.

Any ideas how it should be done? :confused:

Export your generic remote after doing changes.

I think that Cubase loads last exported or imported setup.

Even if something goes wrong, you only need to import your setup instead of redoing it again.

Yes that’s what I must do. :slight_smile: