Project Grid display... am I missing something?

I thought C6 was finally able to display grids other than 16ths - if so how do you activate it??

Mine stubbornly refuses to show anything other than 16ths…

It’s worse than I thought - the quantise grid has disappeared from the key editor too…

Must be an on/off switch SOMEWHERE…

You have to choose ‘Use Quantise’ instead of ‘Bars’ or ‘Beats’ in the Grid Selector.

This is a bit weird as with the other settings you go back to a 16ths display. Better than before, but still not very good.

Thank you.

Yes, certainly better than nothing. I suppose logically there’s not much point in seeing the grid at quantise resolution unless Snap is also set to the quantise value.

Is there is some good reason why the rulers remain set to 16ths? Maybe it would take a major re-write…

In the key editor, I just couldn’t see it because the vertical grid line intensity was set way too low.

In fact with all 3 faders set to max in the Appearance prefs, it’s still not exactly obvious.