Propagate part formatting in Engrave

I just updated to 4.0.3 and suddenly I can’t use Propagate Part Formatting when working in Engrave. This is a bit sad since the parts layout are done in Engrave and not in Setup. Why is that removed?

If that happened to work before, it was only by chance rather than by design, I’m afraid. We tightened up a few of the Setup mode commands for the purposes of ensuring the jump bar works as it should. But I will see about making it possible to use this command outside of Setup mode in future.

1 Like

I think this only worked on my Windows computer and not on my Mac. Anyway, it’d be great to be able to use it in Engrave again, either via a JumpBar shortcut or as before.

Thanks! :slight_smile: