Rendering Metronome track to audio file - similar to Cubase V11

Cubasis
1

Is it possible, in Cubasis V3, to render the metronome to an audio file - similar to Cubase V11 function? Thanks.

2

Hi @Larry_Wersen,

Thanks for your message.
It is not possible to render the metronome to an audio file with Cubasis.

But the Keys/Pads come with Note Repeat support, which might be of help to quickly create a click track, which easily can be converted to an audio file via Track Freeze afterwards.

Hope that helps!

Best wishes,
Lars

3

Thank you for your help!

1 Like
4

Hi Lars,
I have one more question. Is it possible to set the “sounding range” for a track in Cubasis? I have 2 tracks on the same MIDI channel, but do not want the incoming MIDI to trigger them the same. I have a trumpet in track 1 and a bari sax in track 2 and am hoping to limit the bari to “play” only MIDI notes below C2 and the trumpet to “play” only above C#2.
I hope I’ve explained myself clearly and appreciate your answer.

Best Regards
Larry Wersen

5

Hi @Larry_Wersen,

So far, this is not possible with Cubasis.

You might check out if a dedicated third party AU controller plug-in is available who support this.

Would also suggest to raise this question in the Audiobus forum, where you will meet lots of friendly and supportive iOS users!

Hope that helps!

Best,
Lars

6

Thank you, Lars! I had done a bunch of research& found no solutions -so I expected your answer, but hoped for a solution.

Thank you for taking the time to assist and respond.

Best Regards

Larry Wersen

1 Like