Je viens de musescore et utilise Dorico depuis qq mois. Je suis tout nouveau sur ce forum, excuse-moi d’être (poeut-être) mal à droit.
Le défi : un chant (Humblement, dans le silence) où :
-
d’abord le refrain
-
après répétition du refrain
-
contrechant-1
-
refrain
-
contrechant-2
-
refrain
-
contrechant -2 (2ème lyrique)
-
refrain
-
contrechant-3
-
refrain
-
contrechant-3 (2ème lyrique)
Humblement_dans_le_silence–DP-SATB.dorico (2,1 Mo)
-
refrain
En court : RRC1RC2RC2RC3RC3R
Comment réaliser ceci, en musescore plein de fin-de-reprise que dorico refuse.
Merci d’avance, Theo
Here is a simplified structure which gives the desired playback sequence. In this structure, bar 1 represents the refrain, bar 2 represents verse 1, bar 3 represents verses 2 and 3, and bar 4 represents verses 4 and 5:
After adding the three repeat endings, change the barline at the end of the refrain to an end repeat barline and change the barline at the end of each verse to a double barline. Add a Fine to the end repeat barline and add a D.C. to each double barline. After selecting the D.C. at the end of the second verse, copy and paste it to create a second marker at the same place. Add a D.C. al Fine at a rhythmic position just before the last barline and then move it so it is anchored on the last barline. After selecting the first repeat ending bracket in engrave mode, set the property No. times played to 6 and set Times played for segment to 1,6. After selecting the second repeat ending bracket, set Times played for segment to 2,3.
To simplify the appearance of this structure, select each repeat ending bracket in engrave mode and set its Y offset property to a value large enough to send that bracket off the page. Back in write mode, select all five D.C. markers and enable their Hide property. This will cause the markers anchored on the last barline to disappear. Finally, add the text Refrain at the beginning and add the text to Refrain at the end of each verse:
Thanks so much, John !
Although I have noticed some problems.
The number of repeat zones is 3 in your example and Dorico does not allow a digit higher than that 3. I cannot mention verse 4 or 5 in Dorico.
I created more segments (mesure 16 and mesure 17) to be able to mention verse 4 and 5.
Mesure 18 is created, having troubles with the place of FINE : should FINE be anchored on a barline or anchored on a note ?
Anyhow, the result is usefull, you helped me furtheron in Dorico.
Theo (sorry for my poor english)
Humblement_dans_le_silence–DP-SATB.dorico (2,2 Mo)
The number of repeat endings and the number of verses are completely independent.
Anchoring Fine on a barline is the same as anchoring it at the start of the following bar.
Here is a revised version of your project which I created from scratch:
Humblement dans le silence.dorico (2.1 MB)
