After switching from Cubasis 2 to Cubasis 3 I‘m missing the possibility of routing the metronom signal to a different output. Cubasis is offering this on the Setup-Metronom Page, Cubasis 3 doesn‘t.
I need this funktion. Can I find it elsewhere?
Michael
Hi @Sakey69,
Thanks for your message and a warm welcome to the Cubasis forum!
Please note that I’ve updated my previous response (since my reply was incorrect):
The metronome buttons located on the output channels in the mixer allow to route the metronome to different outputs.
Hope that helps!
Best,
Lars