The info above requested in the previous post will help, if you have a moment.
Finished looking at this. It’s almost certainly hardware related, but hard to be more specific. With my own version, we managed to get one ERROR_CRC by lightly pressing the USB cable on the device, due to the bad connection they have. ERROR_CRC is a USB stack error reserved for very low-level transfer failures.
Copilot took a deeper run through the dmp from earlier and found that the driver had thrown an ERROR_CRC from the device. Given this repros for you each time, it seems unlikely that the loose connection would be the cause so a bad cable is another possibility. That ERROR_CRC comes from a USB hardware failure. The first message Cubase sends after you plug it in fails with a USB error, and after that nothing can be sent to it until it’s unplugged.
You could try a different cable or USB port. Folks never want to try other cables, but they are a very common cause of issues. The underlying issue here is somewhere between the usb midi driver and the device (USB stack driver, any hub, the cable, the actual port, the device, the device’s firmware)
Now, to get you unblocked, you can hand-edit your Port Setup.xml in %APPDATA%\Steinberg\Cubase 15_64 to add a “Hidden” value. This is the same as unchecking the box in the UI, but you can’t get to that because Cubase freezes.
Before editing the file, completely close down every Cubase process. If it was hanging at all previously, make sure you kill it. Reboot if unsure.
From my PC, this is the before. I’m using the default Windows MIDI here, but this will look different if you’re using WinRT MIDI or something else.
<item>
<string name="ID" value="O|Windows MIDI|Mb4fa MIDI Controll"/>
<string name="Type" value="midi"/>
<string name="Subtype" value="system"/>
</item>
<item>
<string name="ID" value="I|Windows MIDI|Mb4fa MIDI Controll"/>
<string name="Type" value="midi"/>
<string name="Subtype" value="system"/>
</item>
this is the after. Notice that Hidden is added to the O (Output) port
<item>
<string name="ID" value="O|Windows MIDI|Mb4fa MIDI Controll"/>
<string name="Type" value="midi"/>
<string name="Subtype" value="system"/>
<int name="Hidden" value="1"/>
</item>
<item>
<string name="ID" value="I|Windows MIDI|Mb4fa MIDI Controll"/>
<string name="Type" value="midi"/>
<string name="Subtype" value="system"/>
</item>
You’re hand-editing a file that Cubase reads and writes, so be careful with it. You probably want to make a backup copy of it before you edit.
Also, if Cubase never saw the Brio beyond the crash, you will need to add those lines. However, you said it was previously working with Cubase, so I assume the lines will be in the file.
Pete
Microsoft