Strange behavior when creating a tie

Hi,
I found this strange behavior when I try to tie the notes, as you can see in the video 1 (write mode)
Trying to adjust the beam in engrave mode, is impossible.(video 2 - engrave mode)
I couldn’t find a solution for this, other then using slur.
anyone can reproduce this behavior?
thanks a lot


Go to engrave mode and in the properties panel change the voice column index of the whole note and the notes above so the whole note sits to the left again. I think the whole note should have an index of 0, while the notes above should have an index of 1.

1 Like

Hi Klafkid,
thank you very much!
I spend a lot of time trying to find a solution.
regards

1 Like