Text and Multirests problem

Hello!

I was wondering if there was any way I could get around this? I want to put ‘VERSE’ and ‘CHORUS’ text in my instrumental parts to indicate where these things are - but when the instruments have rests, I end up with these single bar rests followed by a multirest. It would look neater if I could just put the text above the multirest etc - is there currently a way to do this?

Thanks so much,
Cheryl
Screen Shot 2017-02-27 at 11.12.54.png

Aha! Have worked it out! Create the text in a different bar, then drag it over the multirest in Engrave Mode… :slight_smile: