Hello–
I’d like to request that a UI improvement be made. If you change a slur to be “dotted” and then make it cue sized and then select it in engrave mode, it can be very difficult to tell where the slur begins and ends unless you zoom in a looooot. And even then… (Please see pic.) Basically, the anchor lines and the object being edited shouldn’t be a.) the same shape and b.) nearly the same color; the latter being the real issue. In the attached pic, it isn’t too bad because of how far I’ve pulled the slur and how zoomed in I am. Regardless, I was quite confused earlier until I figured out what was going on. I couldn’t for the life of me figure out why the slur “was still anchored way down there even though I’ve pulled the handle way over here!”. 
Then it dawned on me what was going on.
Thanks!
