UR28m Cubase 8.5 - Seperate Speakers for Click?

WaveLab
1

Hi guys. I used to have a Mac setup with a 2408 and had it setup so that my click and dialogue would come out a set of separate outputs than my main music mix which would be bussed to stereo. This allowed me to have one set of speakers for the music, one set for the dialogue and and a small set of multimedia speakers for the click.

The little ‘click’ speakers had a volume knob that I was able to control the level of the click with. Thus, I always had the click on, but raised the level only when I needed it. I’m trying to setup a system like that with the UR28m and cubase 8.5 and am having a bit of a problem doing that. I know the UR28m has 8 outs so it should be able to handle a setup like that.

The only other option I can think of is ASIO4ALL which might allow me to use both the UR28m (for music) and my onboard audio (for click), but I’d rather avoid that as ASIO4ALL latency is much higher than the Yamaha driver.

Any help would be appreciated.


Thanks
B

2

I think you’ll need the control room to route the click to a separate output.
I agree the UR28 should be able to handle this setup.