Hi,
I have a query regarding the new 828-2024 interface and routing external hardware using Cubase 13. The hardware I own is :-
Cranborne Audio EC2 two channel mic preamp
Warm Audio TB12 preamp
Klark Teknik KT-2a compressor
Klark Teknik KT-76 compressor
Klark Teknik EQP-KT eq’s x2
What I would like to do is be able to choose to record either with the built in preamps on the 828 or my external EC2 or TB12 both raw/dry into Cubase 13 and with either of my compressors.
e.g. On one session I may use the EC-2 with either the KT-2a or KT-76 compressors or even both in sequence whilst recording both the dry raw signal and the compressed signal. On another session I may end up using one of my other external preamps and one or both of my other compressors.
Also, on some sessions I would like to use the EQP- KT’s for mixing.
Can this be setup in Cuemix 5 where I can patch any of my preamps to either or both my compressors using the pre-converter sends or will I need to do this in Cubase? Ideally I would like to be able to this as quickly and easily as possible and maybe have routing presets that I can quickly load?
Is this possible?