Weird selection behaviour (CB3 Full)

Hi folks,

with the selection tool I want to select only what’s inside the box - obviously. But that’s not possible I guess? So I can’t reduce the velocity for certain events at once?

Example: https://youtu.be/R-m_DLGRby0?si=99lJ_bc8QDLaLb3t

cheers,
Tim

Hi Tim,
You have to select each individual velocity bar in a group to change the values, the problem doing it this way is if you tap too hard on a velocity bar, ALL notes will be highlighted. If you just want to reduce the high velocities to same level as the lower ones, just select the whole area and drag it up to the top, then drag them back down to your required level.
Hope this helps.
Mike

Hey,

thanks. I know this effect. But I just need to bring the high values a few steps down. Now I just selected every single note and did the job. But next time I have to select them all over again if I need a small change.

cheers,
Tim