Hi, just getting started with Wavelab after switching over from Bias Peak and have hit a snag, it’s probably something very basic that I’m doing wrong but so far can’t solve it, have searched forum and help file.
Here’s problem, I open a song mix file to master, open some plug-ins in master section (in this case bx dynEQ V2, Dynamic Spectrum Mapper V2 and bx XL V2), adjust to taste, check meters in master section (no red showing), then render file.
It goes through the rendering process and rendered file shows up in new tab but resultant file is distorted and over compressed, it sounds as if it is running back through the master section thereby applying plugins twice but is not. Ive tried reducing levels but I get same distortion and too much compression at a lower level. I go back to un-rendered version and monitor through master section and it sounds fine. Have not tried other plugins yet, could there be an issue with these?
Hence my question, what am I doing wrong?
edit: tried different plugin set and did not experience the same problem with these plugs - bx dynEQ V2, Dynamic Spectrum Mapper V2 and bx XL V2?