As shown in the picture, CC1 should continue with the final value. Why does it cut off automatically? And I’ve tried other MIDI keyboards, and the situation is the same. I’m seeking help. Thank you!
Hi,
How did you produce these data? Did you record or draw? Or was it longer MIDI Part and you cut it? Did you still play the Note when you stopped the recording?
Hi,
I didn’t do anything. After stopping the incoming notes, a breakpoint will occur. I use the control wheel of the MIDI keyboard to control CC1.
Hi,
In this case, the MIDI data wouldn’t appear. You had to insert the data somehow.
So if I understand you right, you were recording the MIDI data. Did you stop the recording, while the MIDI Note was still pressed?
It looks like some device (it might be Cubase) sent MIDI Reset. So I try to figure out, which device did it and why.
Thank you very much for your detailed response! Perhaps I didn’t explain it clearly. I was using a MIDI keyboard to input notes and CC1, and my confusion is this: I remember it used to work like this—if I recorded notes and CC1, even after I stopped recording, CC1 would stay at its last value. (I didn’t manually cut off CC1.) But now, why does CC1 automatically cut off? How should I set it up?
Regarding this issue, I remember that I previously bought a MIDI controller and contacted customer support to help me set it up remotely. They made a lot of adjustments to the DAW and system MIDI settings. Although the controller started working properly, after that, I began experiencing these cutoffs when recording CC1. (I have since switched to a new MIDI keyboard and no longer use the previous controller. I’m currently using a Mac system.)
It really sounds like your MIDI keyboard is automatically sending some MIDI Reset command at times. If you like you can setup a filter for this in Cubase.
Go to the Preferences → MIDI → MIDI Filter
In the Controller section add the entry for CC121
Alternatively you can load the midi plugin “MIDI Monitor” onto the midi track on an midi insert plugin slot. It will show you what is being send at which time.
I have already carried out the operations as described above, and the MIDI Monitor shows that there seem to be only CC1 (Control Change 1) messages and notes.
Hi,
Is this MIDI Monitor showing the data while Playback or while Record?