Hello, I would like to get the rectangular enclosure on my bar numbers to line up with the left edge of the staff line. As you can see in this picture, they are hanging over the edge, a bit too far to the left. I can manually move them, but I was wondering if there was a global setting for this.
Hi @julieps,
you may want to reduce the factory values from Engraving Options/bar Numbers/Enclosure (especially the horizontal padding). This will not move the bar numbers themself, but will mitigate the enclosure offset from the system edge:
example of reduced values:
result:
Thanks for the suggestion. I like the horizontal padding as is. Was just looking for a way to get the left edge of the box lined up, and thought there might be an easier way than manually moving each one.
You can make it rehearsal Marks there you can set the horizontall offset in engraving options. But that is more work.