Bezier automation curves get rewritten as points quite often. Is there a way to avoid this?

Cubase
,
1

It’s hard to say when it happens exactly, but sometimes it will be during a session, and sometimes after I recall a session. Is there a way to avoid this happening? I feel that if you write a bezier curve for automation then it should never go back to interpolated points visually ever (it doesn’t matter that that’s what its doing behind the scenes)unless you tell Cubase to – otherwise it takes multiple extra steps to get that curve back for easy changing.

EDIT: This is in the Project Window automation lanes.

2

Hi,

Did you delete some nodes by any chance?

How did you edit the automation curves?

3

In this case it’s always editing with the bezier curve, and it happens whether or not I delete the nodes that anchor the bezier curves. It doesn’t happen while I’m doing it, just sometimes when I go back to change it later.

4

Are you talking about the automation in the project view or in the key editor?

1 Like
5

In Project View.