Can't see my UR22-C input meters using CB12 and M1 Mac

Cubase
1

As above. I’m running the latest CB12 pro, and Mac 12.5.1 on a MacBook Pro 14.
My UR22-C is working fine, but I don’t get the Input/output meter section in Inspector, nor is there a section in Studio for this. Its in the ‘Ass’ section but I can’t add it.
If I run CB in Rosetta 2 it’s there.
Is this normal?

2

Hi,

Make sure Cubase has enabled Mic in the System Preferences, please.
Open macOS System Preferences > Security & Privacy > Privacy > Microphone. Enable Cubase here.

3

Sorry if I wasn’t clear.
The UR22-C is woking fine, I can use it for in and output. I had already done what you suggested when I installed it.
The issue is I can’t see the input meters for the hardware. There is no UR22-C section in Studio or Inspector when using Native mode. I get the option to add it, but that doesn’t do anything.

4

Here are the screen shots.
This is using Native

Apple Silicon2022-09-11 at 11.28.43
Apple Silicon2022-09-11 at 11.28.431920×1247 173 KB

and this is Rosetta

Rosetta 2022-09-11 at 11.25.47
Rosetta 2022-09-11 at 11.25.471920×1247 175 KB

5

Hi,

That looks like the driver or the component is not M1 native to me. Is the driver M1 compatible already?

6

To be honest i just assumed it would be, as the driver itself (inc its control panel) works ok using CB under Native.

7

Hi,

The official page says it’s under the tests.

8

Yeah, i had seen that page but it’s quite old. The driver itself is fine, as its the Tools, so I assumed it was all going to work.