Changing UR28M Sample Rate In Windows 10

Steinberg Hardware UR Series
1

I am running Windows 10 and the UR28M is defaulting to 48k sample rate in the Windows 10 Control Panel Sound properties with no visible way to change it as it is greyed out where it says 48k. I need to set it to 44k to use my room measurement system. On page 10 of the UR28M manual the screenshots for changing the sample rate in Windows are different to the options I have. Probably as the manual is for an older version of Windows. If I was using my DAW I could change it there but this is just using room measurement software that needs to be at 44k. I have attached a screenshot.

Windows 10 UR28M Settings.jpg
Windows 10 UR28M Settings.jpg655×600 97.8 KB

Please can someone kindly advise further? Thanks

2

I’d hook it back up to the DAW, change the sample rate there, then take it back mobile after that. IIRC, some of the UR28M’s functions are frozen once you disconnect it from the DAW, maybe this is one of them.

3

Thanks very much Alexis that did the trick! :slight_smile:

4

You’re welcome, glad that worked!