ChordPad - Change Octave Of Just One Chord

Cubase
1

When I go to create a set of chords using the chordpad feature, some of my chords are an octave below where I need them to be. For example, two chords I need are Bbm7 and Cm7. However, it plays the Cm7 chord an octave below what I need it to be. How can I change the octave of just one chord in the set? I tried to enter the chord from my midi controller, but that either does not work, or I went about it the wrong way.

Thank you for any help that can be offered.

V

2

Have a look at “adaptive voicing”. You can disable it for any specific chord. Afterwards the shift of “voicings” should allow you to make the chord an octave higher.

Does this help you already?

3

Thank you for your reply. I was able to use the transpose feature to go up 12 semi-tones to get the desired result. I was not sure if that feature limited you to 11 semi’s or I could go past that range to 12.

Thanks,

V