how to do for not to hear the clean sound when we use Sgear guitar plugin?
both sounds is on the speaker and direct monitoring is off
Hi and welcome to the forum!
Have a look at your interface - is there a knob reading something like “Mix - Direct”?In that case turn it fully anti-clockwise.
If that is not the case, please provide more specs and a screenshot is most welcome;)
dont have knob on ur44c
Yes, you do… look closer…
Sorry, my bad, I confused it with another Steinberg interface…
Back to the screenshot, please.
Sorry again!
onley 4 inputs 4 volume knobs for inputs ! 2 inputs for phones
and one big knob to the rigth who is out put onley
Yes, I know… have a look at my last post which I edited after a few seconds. My mistake! I had the UR22C in mind - have neither of them and just know them from troubleshooting here in the forum.
Nothing suspicious at first glance.
Please have a look at your DSP monitoring that comes with the UR44C ( 
)- the culprit might be hiding there!
can you show a pic off that?
Sorry, I am not working with the UR44C as I wrote before. It is a separate software that goes along with your interface. You should see it somewhere as an icon. Can you post a screenshot, too?
Another idea: is there a mix knob in S-Gear which let you define the ratio between direct signal and the processed signal? I am not familiar with S-Gear but I know that some amp emulations have this option.
Just to make sure: You put S-gear on an insert slot, right?