Hi Folks, I am using an EMU 1212M card and just want to achieve a simple process to use a hardware plugin. None of the input busses I create will let me select the EMU ASIO even though it shows up as an option. Every time I select it it just goes back to “not connected” in the box. Some signal mus…

Sounds like a bad driver… what are all your system specs?

Hi, Glenn Seems strange as everything is working here, with Patchmix. Be sure that : there is a ‘Send’ to an ASIO input pair (from ASIO IN 1/2 to 31/32) affected to each channel strip in Patchmix, otherwise the channel won’t be available as an ASIO input in Cubase. each channel is muted, to avoi…

Also, if you’re new to it, it’s easy to load the wrong template into Paychmix. Make sure you haven’t loaded the 1616 set by mistake, say. Driver check could be helpful too. 64 bit / 32 bit? If you have the latest Emu driver and have problems it might be better to use the last driver before that. P…

Hey Guys, Thanks for the input. Tried the tweeks suggested and eventually got frustrated so bought UR28M. Again, not obvious but I got it working how I wanted eventually. Your time and expertese was much appreciated, Cheers, Glenn

Hmmm… It’s a different kind of beast : USB, not exactly cheap (450 €) and still no MIDI implementation. I keep on wondering what is the reasoning behind this, as Cubase is, actually and historically, a MIDI sequencer… Beside this, no ADAT connection either. Could you give us a feedback latency rel…

Hi Cubic, and Happy New Year. I went for the UR as I just wanted “turn Key” audio routing from within Cubase to bring my hardware units into play. As you will see from my other thread on here the UR manual was not very obvious and I had quite a few issues firstly for setting up the external inserts…

The latency is interesting. Mine is showing 22ms. I put it at its lowest setting as an experiment and it popped and crackled. I’m on a mix at the moment and will be bringing VST instruments in tomorrow, so will report back with any playability quirks. Laterz, G

Thanks for the feedback, Glenn Well, 22 ms… Hope you will be able to reach better values (it’s nearly unusable at the tracking stage at more or less 20 ms ; the delay is too obvious, IMO). Otherwise, could you precise what is your MIDI implementation as, maybe, I will have to consider a setup with…

In fairness they have recently updated the 1010 card with a PCIe version and new drivers. For exactly these reasons I decided a few years back to replace my 1212M with a RayDAT because (a) IMHO they have the best drivers and (b) I wanted to get all analog I/O “out of the box”. I now have hardwar…

Well… The 1010 at its present PCIe state was existing in 2009 already. It’s the one I have as a part of the 1616m system, this with the present audiodock : Nothing really new here. On the other hand, the driver seems to have lost its beta state, which was lasting for more than one year, but it’s st…

Steinberg Forums

Emu ASIO input

Cubase

cubase-older-version

cubic13 January 5, 2012, 9:00pm 20

Done !

Steinberg Forums – 5 Jan 12

Syncing a Raydat and 2 other units via ADAT...

Hi all, Following a discussion about E-Mu and its unsure future (Emu ASIO input - Cubase - Steinberg Forums), I was wondering if a RME RayDat could be a solution for replacing in a more or less far future what I already have (see my sig) and if so,...

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled