I can’t hear sound from audiotrack through routing only if i send this track through send channel to the same track which first one was routed. Moreover when this audiotrack even not sent trough send channel other send channels hear it and produce reverbs an delays from this track which i didn’t hear. Volume 0db, faders 0db, analyzers from mixer shows full signal but no sound! Other audiotracks and synths works perfect. Sign of monitor offed. What could it be?? 
Hi and welcome to the forum!
Can you post a screenshot of this audio track with its routings, please?
This way it’s easier/faster to say/see.
1 Like
What happens if you set routing direct to Master? You hear it OK?
Do you hear other tracks that are routed to LEAD VOX (if there are none try one)?
Might be easiest to upload the cpr so we can check through all your routing as you’re going through multiple group tracks on the way to master. Could be some feedback protection from one of them that you’re not showing.
Thanks for your proposal, but yeah I tried to route it directly to master - no sound, just sound from FXs, and as well VOX is perfectly monitored by dB meter but still no sound. Also I’ve just tried to send another audiotrack (Snare from Playlist) to Lead Vox(bus which my unsounded VOX routed) and Snare sounds! Everything’s ok exept my vox.
What happens if you route directly VOX 1 to ALL VOX ? Any sound either ?
EDIT - Additionaly, I would also try to use the Deactivate all solo/mute states tools (in the arrange page), as all your mute/solo settings seem a little messy…
What happens if you remove “SPAN” from inserts?
Thinking of an non-working plugin cause here.
Thanks for your advice, but yeah I’ve routed VOX 1 to ALL VOX, and also no results, solo/mute states it’s just a working state screenshot, believe me I’ve tried various settings with it, as well nothing works with all channels without solo/mute button on
I’ve removed SPAN but still no sound, also dB monitors works, maybe my problem connected with (Audio outputs: not connected?) but I have working control room and I think it is how it should be, no? Otherwise why when I send snare through VOX, snare starts to sound?
I partly decided a problem , I made a new channel and recorded a new take and all started to sound, but I’m curious about the reasons of my situation, I wouldn’t want to experiense that furthermore in my work and rerecord good takes. Could it be issues with preferences of an audiofile itself?
I’ve seen references to how when “new track” creation fixes the issue that volume automation in the existing tracks could have contributed to the issue. Not sure if that applies in your case, but it may be something to look for.
Can you please tell me where I can find automations of audiotrack in Cub14?
Sure, just right-click on the track and go down to “Show Automation.” There are options for “Hide Automation” (once it is shown) and Show All Used, etc. There are also corresponding key-commands for each 