I’m having a lot of trouble locking to external clock with an RME card in Wavelab on Windows 11.
The RME card seems to get ‘stuck’ at 1x or 2x sample rates.
The master clock is my ADC, and the RME card is in ‘sync’ with this sample rate, which is also displayed in the lower right hand corner of Wavelab.
If I start working at 96k but change the sample rate at the ADC to 44.1k, Wavelab sees the new sample rate at 44.1k but can’t play as the card shows 96k in red, but the ‘current’ sample rate as 88.2k. Similarly, if I go from 48k to 88.2k, the card stays at 44.1k.
The issue persists with “Sync In” and also with Word Clock.
In other words, the RME sees the new rate at its input, Wavelab sees the new sample rate, but won’t play audio. The card’s active sample rate is half or double this rate.
The card is in Single Wire mode for AES connections but changing this option doesn’t help.
Occasionally I can get it to work by ‘refreshing’ the Audio Connections in Wavelab, but this crashes Wavelab just as often as it helps.
For years this way of working went well with a Lynx AES card, but since I’ve been using the RME it doesn’t work.
When WaveLab plays an audio file with a given sample rate and then with another sample rate, WaveLab orders the audio device to change its sample rate, but if its sample rate is externally clocked, the audio device will reject the request.
If you use multiple sample rates, it is recommended, of course, to use an audio device that is not externally clocked. Otherwise, you could use the resampler plugin in WaveLab so that WaveLab does not need to request a sample rate change to the audio device.
I have a TASCAM CG-2000 clock that feeds my RME card. I have it setup so I can quickly change sample rates so no problem. My whole studio is locked to the CG-2000. I did this because I was getting “clicks” and other clocking problems in my audio. FWIW