MCU/MCU pro Send-FX bus sending with Cubase

Hi all !

Could MCU/pro users here try the following and tell me what they get on the scribble strip ?

  1. open project in Cubase or create new one and add just one audio track.
  2. on MCU, go to send-fx mode (press DYN on MCU) and select the track (or any audio track).
  3. scroll to page 4 of this mode (aux-send-destination choice).

What do you get on the scribble strip LCD display ?
Normally, it should read BUS BUS BUS BUS BUS BUS BUS BUS (one for each send) or at least NOBus NoBUS…or something similar.
Currently testing a new controller acting like a Mackie control and when I go to page 4, I get nothing. I have to push “Parameter/Name” to see the parameter it is supposed to adjust.

A photograph of the scribble strip would be great.

Thank a lot.

Hi !

Up.

Sure some of you use an MCu with Cubase ;o)

Thanks.

Hi !

Up.

Hi !

Up again ;o)

Hi Jerome

Try this

https://www.steinberg.net/forum/viewtopic.php?f=81&t=23394

Andy

Hi !

Got the reply in the footnote, thanks. Then it comes from Cubase (or how the MC protocol is implemented) and not my controller (iCON QCon Pro). Could not remember how it used to behave with the MCUs I’ve used.

Thanks.